![]() I’m using 1/2” hardware cloth for this and it’s job is to keep anything that can eat chickens, away from the chickens. ![]() Then once the framing was done I also gave it a coat of paint. Again, since I have a nailer that’s what I used to make it go quicker. I used up a lot of the off cuts from making the walls for this. Keeping myself busy while those were drying, I started making the door to the run. So I propped the walls up with some scraps and gave everything I could reach a good coating. And take my word that it’s muuuuch easier to paint before any screening goes down. The entire run is wrapped in hardware cloth to keep chicken-eating-critters out. With the walls put together I next paused to paint them. We don’t get snow in my part of Texas so my angle is really shallow but this can easily be changed by just making the studs of the wall taller in one wall. In order to have the rain run off, I made the front wall a few inches taller than the back wall. ![]() I’m using a nailer because I have one but you could also go with a drill and screws.Īfter I built the first wall, I repeated the steps to make a second the same way. You could, of course, build the wall on site but it will be much easier to build on the flat floor then transport them afterwards.Īfter cutting each of the studs to length I quickly marked off where each one needed to go, used a speed square to transfer the location to the top plate of the wall, then started attaching the studs with a framing nailer. I started off by flipping the wings out on my Wilker Do’s miter saw stand and cutting some 2x4x to length on my miter saw in order to build a wall. ![]()
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |